LX-177: Polyethylene Foam Carrier

Coated both sides with a high performance acrylic adhesive that offers excellent weather resistance on exterior applications. It is also resistant to solvents, plasticizers, chemicals, UV light and extreme heat. Offers an inexpensive alternative to the Ultra High Bond solid acrylic foam tapes. Peel adhesion: 6.4#'s/inch

LX-177 is coated both sides with a high performance acrylic adhesive and protected on one side by a plastic release liner. This product offers excellent weather resistance on exterior applications. It is also resistant to solvents, plasticizers, chemicals, UV light and extreme heat. Note that acrylic adhesives take from 24-48 hours to cure to maximum bond strength once applied; any testing should take this into consideration.

Note: Be sure surface areas are free from contamination before applying LX-177.

All technical statements and recommendations contained herein are for use as general guidelines only; it is the buyer's responsibility to thoroughly test each and every product to ensure it meets his particular requirements. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective. Neither the seller nor the manufacturer shall be liable in either tart or contract for any loss or damage direct, incidental, or consequential, arising out of the use or inability to use the product.

Specifications

Color: Black
Foam Density: 8 lbs/cubic foot
Adhesive: Acrylic
Product Thickness: 1/22 in
Peel Adhesion PSTC-3: 50 oz/in
Service Temperature: 0 - 176 ºF
Liner: 4.0 mil green Polyolefin
Shear Adhesion (PSTC-9): At 77 degrees F over 24 hours with 4.4 lb loading on a sandwich holding stainless steel plates of 1”X1”
Heat Resistance: At 176 ºF over 24 hours with 2.2 lb loading on a sandwich holding two stainless steel plates of 1”X1”
Tensile Strength: Over 100 lbs/1”X1”