LX-211-A: 8.2 Mil Double Coated Clear (Polypropylene) Banner Hem

High peel acrylic gives "instant" hems on vinyl banners. This transparent tape is resistant to moisture and temperature variations. Peel adhesion: 80 oz./inch

LX-211-A is an 8.2 mil double-coated polypropylene film, which features a very high adhesive mass of 3.5 mils each side. Allows adhesive flow into rough or irregular surfaces. Is resistant to plasticizers, temperature variations and is water and moisture resistant. Bonds well to vinyl, plastic and smooth or textured surfaces. Commonly used as a banner hem tape. As with all acrylic adhesives, once application surfaces are cleaned and the tape is applied, allow a minimum of 24 hours for the adhesive to cure to maximum bond strength before conducting any testing.

Note: To achieve ultimate adhesion, the bonding surface should be dry, clean and free of dirt and oils. The strength of the adhesive bond is dependent on the amount of surface area directly contacting the adhesive. Firm pressure is recommended to obtain good adhesive to surface contact.

All technical statements and recommendations contained herein are for use as general guidelines only; it is the buyer's responsibility to thoroughly test each and every product to ensure it meets his particular requirements. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective. Neither the seller nor the manufacturer shall be liable in either tort or contract for any loss or damage direct, incidental, or consequential arising out of the use or inability to use the product.


Total Thickness Without Liner: 8.2 mil
Adhesive Thickness Each Side: 3.5 mil
Carrier Thickness (Polypropylene): 1.2 mil
Adhesive Color: Clear
Release Liner: White Silicone Release Paper
Peel Adhesion: 80 oz/in
Temperature Service Range: -40 to 200 ºF

  • Model: LX-211-A

Your IP Address is:

Parse Time: 0.091 - Number of Queries: 135 - Query Time: 0.0565152993927